Rounding Corners
Run Auto Cut with the following settings:
Make sure that in the Corner Treatment section, the Use Technology Table option is not enabled, and that the Delete old before running options are indeed enabled.
Now zoom-in to corners of the part, and they should look as follows:
|
The Bend Relief
 |
The Notch outer corners
 |
The Chamfered corners
 |
|
If your corners look like this:
 Toggle the Full Cut Tool Width option in the View menu. You can also use the keyboard shortcut Ctrl+B. |
We will now add Rounding to the corners. Open Auto Cut again, go to the Global Cut tab and set the parameters as follows:
Max Angle – 90
Rounding, Active – enabled
Rounding, Size – 0.5
Run Auto Cut again, and look at the corners:
|
The Bend Relief
 |
The Notch outer corners
 |
The square holes’ corners
 |
Note that in each case the cutting line is an arc instead of a straight angle.